Version Effective

Change

1.057

Fixed "Host: End Stage Plot Missing" error in the strobe program code.

Fixed the cassette auto selection mode algorithm.

Parameters Display Improvement - both image size and total size viewable (In the first parameters screen, the total size [image + margins] parameters are viewed while in the second one, you can see the original image sizes).

Parameters screen display does not disappear when a message is invoked.

Fixed incorrect interrupt handling in OMC code.

Fixed film update length in the set loading command.

Humidity Display - This value will be supplied from the Res Ctrl board (not implemented yet by hardware – Dolev 800V⁴)

Res Ctrl Alarm Status - This version inspects the Res Ctrl alarm signal and stops the imagesetter if necessary (Dolev 800V⁴)

Infrastructures for simple commands – New simple tasks were added for serving commands from the host at imagesetter idle time
(Dolev 800V⁴)

1.058

Fixed incorrect plot size calculations while using the punch. (The error message was: "Expose Size Exceeded".)

Fixed the unloading problem while using multi flat mode. Whenever one plot has failed (except the first one) the film was not unloading.

Changed maximum roll length to 75m.

The machine initializes the resolution to 100 dpm (Dolev 800V⁴) at startup.

The Tec’s of the Static Optic is Shut OFF after 30 minutes of no exposing (Dolev 800V⁴).

1.059

Solved the unloading bug that caused machine to remain in unload mode after film was finished loading.