The Flexcel NX Laminator Self Study Guide courseware is now available on TechPlanet.
Go to Training on the Reference page.

Go to the Safety page.

These instructions are delivered with the device to allow non-Kodak personnel to partially unpack the laminator.

Go to Flexcel NX Laminator Unpacking Procedure on the Installation page.

After you put a plate on the table and press the VAC button, the LAM button does not blink. This procedure includes possible resolutions that operators may perform, and appears on eCentral.

Go to LAM button does not blink under Buttons/switches on the Troubleshooting page.

After you put a plate on the table, the VAC button does not blink.

Go to VAC button does not blink under Buttons/switches on the Troubleshooting page.

This diagram shows the layout and functions of the LEDs in the PLC.

Go to PLC LEDs Diagram under See also on the Troubleshooting page.

This guide describes how to replace the laminator parts and assemblies.

Go to Flexcel NX Laminator Service Guide on the Procedures page.

This guide describes how to unpack, install, and test the laminator installation.

Go to Flexcel NX Laminator Installation Guide on the Installation page.

The safety precautions guides for operators and for service personnel are now available.

Go to Flexcel NX Laminator Safety Precautions for Service and Flexcel NX Laminator Safety Precautions for Operators on the Safety page.

The VRG shows how to load and laminate a plate, and how to maintain the laminator.

Go to Flexcel NX Digital Flexographic System Visual Reference Guide - English on the Reference page.

Go to Flexcel NX Digital Flexographic System Installation Test Procedure Checklist on the Installation page.

Go to Flexcel NX Digital Flexographic System Site Preparation Guide on the Installation page.

The FRU parts list is now available. More illustrations will be added in the near future.

Go to Flexcel NX Laminator FRU Parts List on the Spare parts page.