FCO 510F28845 - Sealing Horizontal Grooves in Drum

Description

The horizontal grooves in the drum close to the head spoilers cause large plates to get stuck on the drum. To prevent this, the grooves were lowered on newer models of the Lotem 400. If the plate gets stuck on the drum in older models, this FCO should be implemented.

Prepared By: Haim Vaknin & Mario Amir	FCO Kit No: 510F28845
Comp. Level: N/A	Machine S/N:
Catalog No: N/A	S/W Affected: N/A
Type of Change: CONDITIONAL	Estimated Time to Implement:
Product Mgr: Yehuda Solomon	Approval Date:
Product Support: Haim Vaknin	Approval Date:
Customer Support Mgr: Assaf Zach	Approval Date:

Reason For Change

Plates larger than 680 mm can get stuck in the horizontal grooves on the drum.

Description of Change

The horizontal grooves on the drum should be sealed with epoxy glue.

To seal the horizontal grooves

Spread a small amount of epoxy glue evenly in the horizontal grooves on the left and right sides of the drum, as shown below.

Clean any excess glue from around the groove, so that the surface is completely smooth.

Note: Excess glue around the groove can cause problems upon exposure.

After the glue has completely dried, test plate attachment to Drum pins by loading a plate.
Readjust the loading parameters if required.

Parts List

N/A

Attached Documentation

None.

Material Disposition

N/A

Logistics

N/A