Applies to

• Lotem 400
• Lotem 400 (small)
• Lotem 400 with MCU
• Lotem 400 with PS/M

Priority = Next visit
Release date = 01 Sep 2002
Type of change = Conditional

Component

Problem

Air pipes do not connect tightly to the Y connector.

Solution

Time needed to implement

1 hour

Parts needed

Procedure

1. From the Lotem application, open the rear door, and then shut down the machine.
2. Disconnect the air pressure.
3. Open the right side door, and then open the light cover.
4. Disconnect each of the six Y connectors from their air pipes. 



5. Connect the new Y connectors (P/N 344D57020) to the air pipes, fitting the air pipes into (instead of over) the Y connector.
6. Close the light cover, and then close the right side door.
7. Connect the air pressure.
8. Close the rear door, and then turn on the machine.

Logistics

Approved quantities:

Material Disposition

Dispose of old Y connectors (P/N 344D71100).

Technical contact

Mario Amir

Product Support Manager: Haim Vaknin
Approval Date:

Date submitted