Lotem 400

LOTEM 400 - SMALL
Release Note

Lotem 400Small –501S4E192
Lotem 400Small with MCU – 507F4E037

The Lotem 400 Small will support a wider range of plate sizes:
Minimum: 311 x 228 mm (12.25" x 9") around x along drum

Maximum: 622 x 750 mm (24.5" x 29.5") around x along drum

• 6 head and tail spoilers/grippers on the drum
• Additional vacuum groves on the drum
• Different weights for balancing
• Load/Unload gripper actuators with 6 pins

• Left present detector not active – S/W
• Right present detector moved closer to center to support smaller plates.

• The cassette centering system can move further to the center to support smaller plate sizes.
• The fufu has 6 nozzles instead of 5.
• The loading bar has 6 suction cups.
• The tweezers width and location on loading bar have been changed.
• The bar flag has moved to the center.
• The new plate centering system supports smaller plate sizes.
• The short pins base has been modified to prevent small plates from getting stuck on the base edge.

All other specs remain the same as those of the Lotem 400. (See attach spec for Lotem 400 Small, below.)
Following are the changes required in the registry to support the wider range of plate sizes:
Under:

MACHINE/ Min Media Height Size (mm) change from 330 (default) to 228.
Hardware/Drum system/Balance system/right click Balance system/
Balance Weight Mass (gr) change to 505.6
Tail Gripper Total Mass (gr) change to 1162

For Manual Loading only,in the Regedit change: IO Objects/Local 3/Detectors/Plate Present Left Detector from "1" to "0"

Perform Shutdown and start application.
On the GUI go to Utilities/User/User type/Service Engineer type the Password: Creoscitex
On the GUI go to Settings/Plate definition/ in the media definition box dialog open the ADV
Dialog erify : Position Type is on "Edge"

Note: Make sure the processor can handle small size plates.

The Lotem 400 Small is in BETA stage – Expected time for Beta 4-6 weeks.

Media

Resolution

Screening

Accuracy

Throughput

Loading /Unloading