Product

• Lotem^® 400
• Lotem 400 Xpose
• Lotem 200K

Error

Symptoms

When starting the Controller application, Put and Get actions do not succeed and the DDB OPCOD83 error message appears.

Cause

• One of the doors is open when starting the application
• The BIOS setup is not current
• The NUC board comp level is not current
• The .hex file is not current

Solution

1. When starting the application, verify that all doors are closed.
2. Verify that the BIOS setup is current and update the BIOS if required. (See the relevant downloads page in TechPlanet.)
3. Verify that the NUC board is comp level N or higher and replace the NUC board if required.
4. Rename the following files:
   • ddb-wcs.hex (Lotem400\UpLoadFile\DDB\TSP)
   • mem_mod0.rbf (Lotem400\UpLoadFile\DDB\VLSI)
   • mem_mod1.rbf (Lotem400\UpLoadFile\DDB\VLSI)
5. Install the following files in place of the respective files in step 4.
• ddb-wcs.hex
• mem_mod0.rbt
• mem_mod1.rbf

Technical contact(s)

Mario Amir

Submitted by

Mario Amir

Date submitted

15 Dec 2004