Field Change Order #27624 - DLC Tray Stopper

Prepared By: Gabi Ra'anan	FCO Kit No.: 510F27384
Comp. Level: N/A	Machine S/N:N/A
Catalog No. : 27624	S/W Affected: N/A
Type of Change: Conditional	Total Number of Pages: ?
Product Mgr: Nir Halup	Approval Date:
Product Support: Gabi Ra'anan	Approval Date: Apr. 19,2001
Customer Support Mgr: Kuty Paperny	Approval Date:

Reason For Change

This stopper prevents the upper tray from sliding beyond its "out" position thus keeps the tracks from breaking apart.
Description of Change

Installation of a stopper beneath upper tray.

Change Procedure
3.1 Remove 4 upper screws on each side of the upper tray [see photo # 4306].
Note:Do not remove the lower screws that attach the rails to the cover as it requires readjustment of the rails and upper tray !

3.2 Position the red jig supplied as shown in the drawing (422 mm from right the edge) [P.# 4307] .Drill 3/16 (or 4.5 mm) holes through the jig.
Note: Place a paper sheet in the lower compartment to collect the chips from the drilling!

3.3 Raise the lower compartment cover and install the stopper; It's attached with two 8/32x5/8 scerws to a small threaded bar which you have to insert through the beam under the cover [P.# 4308,4309]. Use Blue Loctite 242.

3.4 Install the upper tray and use Loctite to secure the screws.

Test Procedure
Move the tray up and down couple of times and ensure smooth operation. Load few plates
And verify proper loading on the drum.

Approved quantities: