Field Change Order #27753 - Improved DLC Connectors

Description: Replacement of DLC connector PCB

1. Reason For Change

• Improve durability of connector.

2. Description of Change

Removal of existing PCB (C.L. K) from the connector and installation of a new One (C.L. L).
The new PCB has a thick layer of lead coating on the contacting surfaces.
This protects them from being grinded by the male connector pins.

3. Change Procedure

Disconnect the white Molex connector on the backside of the assembly.
Remove 6 smaller Allen screws (see picture below), remove coonector assembly
From loading panel and disassemble the PCB board (held by 3 Philips screws).
Install the new PCB and put evrything back together. Do not forget the white isolating piece out!
Make sure the connector assembly is firm on the loading panel and tighten the large screws if necessary.

4.Test Procedure

4.1 Verify that connector pins are centered at contact surfaces off the Machine.
4.2 Check the new connector for electrical functionality; Engage the cassette with the machine and open all relevant detectors and \
solenoid windows in the GUI (HP, End position,Latch); Acivate solenoid,push the upper tray in and out and see that all detectors
and solenoid function properly.

5. Parts List

6. Attached Documentation

None.

7. Material Disposition

• Trash the old PCB.

8. Logistics

Approved quantities:

Schedule supplies for first lots