Previous Page  ToC  Next Page

Launching Diagnostics

1. From the Start menu, click the Lotem 800Diag to launch the Diagnostics.
2. In the window that appears, localhost is listed. If you want to run remote diagnostics, replace localhost with the IP address of the remote station.
3. In the window that appears, if the Lotem 800 you wish to test is listed, continue to step 4. Otherwise, select it from the pop-up list.
4. Click Finish. The Lotem Main Diagnostics window appears. Continue to "Diagnostics Main Window".

The Diagnostics startup process begins and the diagnostics initializing message appears.

If a problem is detected during startup, the Startup info window informs one of the following:

• A board is not configured or a board self-test failed. In this case, you can click Continue to go on with the Diagnostics process and the Lotem Main Diagnostics window appears, or Abort.
• One of safety interlocks is activated. In this case, you must solve the problem that caused the active interlock and click Retry, or Abort.

Copyright (c)1998 Scitex Corporation Ltd. All rights reserved. Certain names, logos, designs, titles, words or phrases on this page may constitute trademarks, servicemarks, or tradenames of CreoScitex Corporation Ltd. or other entities which may be registered in certain jurisdictions.

Top of Page  Previous Page  ToC  Next Page