Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
The table below provides information regarding the status of the laser calibration
and laser diode driver (LDD).
Run the calibration task and then refer to the table to view the status of the
calibration.
| Log No. |
Log Number Interpretation
|
| 255 | LED (diode) is not calibrated. If this log number appears for the first diode then the problem is probably related to either the DDB, LDD, local board or diode. |
| 00 | LED (diode) calibration is successful. |
| 01 | GT~ active with LED (diode) intensity = 0 |
| 02 | GT~ and LT~ active @coarse. The problem is probably related to the DDB or local board. |
| 03 | Coarse value is less than 1. The problem is probably related to the LDD, but it may also be diode related |
| 04 |
GT~ active noise pulse @Fine |
| 05 | GT~ and LT~ active @Fine CAL The problem is probably related to the LDD but it can be also the diode. |
| 06 | LDR (LDD CARD)_STAT bits not equel ‘0’ at Status Check before start of Auto CAL |
| 07 | LDR (LDD CARD)__STAT bits not equel ‘0’ at Status Check after end of Auto CAL |
| 08 | Intensity reached to maximum while LT~ flag still active, it can be LDD, local or diode. |