Bad Default Parameter Values in Version 3.20.01

Prepared By: Itai Peperovich
Date: 4 Apr 02

Description

The following default loading system parameters in version 3.20.01 are not appropriate, and must be reset:

• Paper Y Down in Cassette
• X For Open Paper Clips

These parameter values will be corrected in Version 3.6.

Paper Y Down in Cassette

This parameter determines how far down the XY system goes to retrieve the slip-sheet from the cassette.
The default value of 35 mm is too large and can cause damage to the loading system as well as loading problems and error messages. The suction cup bar cannot really go that low in the cassette, so it pushes against the bottom of the cassette.
It is strongly recommended to change the value of this parameter to 6.

X For Open Paper Clips

This parameter determines how far into the cassette the XY loading system goes to open the paper clips before picking up the paper.
The default value of 395 mm is too large and can, in some cases, cause the XY bar to hit the front panel screws, cause a mechanical collision and damage the loading system, as well as loading problems and error messages.
It is strongly recommended to change the value of this parameter to 386 mm.