Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
An improved mainframe or chassis has been developed for the platesetter. This latest mainframe, referred to as the Type II mainframe, is more functional than its predecessor (Type I mainframe) and contains greater service access.
Note: To visibly distinguish between the two types of mainframe, see Distinguishing between Type I and Type II mainframes.
This page describes the improvements made on the Type II mainframe:
|
Part
|
Photos
|
Improvement
|
|||
|---|---|---|---|---|---|
| E-Box |
 |
New SBC 786 board. | |||
| Keyboard/mouse Y splitter cable (p/n 609-00281) |
 |
Only one keyboard extension cable (p/n: 199D20220) is connected to the 800 II accessory kit. Connect one end of the cable to the SBC and the other end to the Y splitter cable. | |||
| TMCE Board |
|
Moved to the right door to allow better service and replacement
access. A screw from the Type II mainframe's body closes the TMCE door. Note: After you open/close the TMCE door, make sure that all the wiring is in place to avoid circuit shorting and damages. |
|||
| CA Board |
|
Moved to the right door to allow better service and replacement access. The CA board is the smaller board above the TMCE board. | |||
| Power Fail Protector Board Assembly |
 |
When power surges occur, the power fail protector board assembly maintains the platesetter in OFF status until the On/Off pushbutton is toggled. |
|
Part
|
Photos
|
Improvement
|
|---|---|---|
| Power Supply Tray |
 |
Removed, and relocated inside the distribution box. |
| Left Local Board |
 |
Moved from the left side door upper compartment to the lower one, instead of the power supply. |
| Cooling Filter 24x12 |
 |
Better service and replacement access. The filter is held by two pull-out latches, which are activated by the customer. |
|
Part
|
Photos
|
Improvement
|
|---|---|---|
| Drum Vacuum Pump |
 |
Moved to the place of the cooling system. |
| Debris Vacuum Hose |
 |
Moved towards the left side door. Note: This change also required a change at the distribution panel and therefore, a new part number. |
| Loading Vacuum Pump |
 |
Replaced with a vacuum generator unit located above the drum vacuum pump. |
