FCO 510F27849 - Flex2630 Load Tray for Cleaning

Description
This FCO explains how to replace the Load/Unload tray to enable easy access for cleaning
the nozzle.

Prepared By: Yaron Soffer	FCO Kit No: 510F27849
Comp. Level:	Machine S/N:
Catalog No:	S/W Affected:
Type of Change: Mandatory	Total Number of Pages: 3
Product Mgr: Yehuda Solomon	Approval Date:
Product Support: Yaron Soffer	Approval Date:
Customer Support Mgr: Assaf Zach	Approval Date:

Reason For Change
To enable easy access to clean the nozzle.
Description of Change
1. Remove the old loading tray.
2. Disassemble the rubber roller and assemble it in the new tray.
3. Install the new tray.
4. Explain to the customer how to clean the nozzle.
Note: Remember the customer is not allowed to use a cheater.
Change Procedure
1. Undo and remove the loading tray.
2. Disassemble the roller by opening two screws on one side of the roller support arm.
Note: Pay attention to the roller end shaft. The side with the long shaft should be located on the left side of the tray.
3. Install the roller from the old tray, leaving a gap of 2 mm between the E - ring and the white bearing.

4.Pull the adjustable brackets all the way up and tighten them moderately.
5.Gently close the door; the brackets will be pushed to their correct position.
6.Open the door carefully and tighten the brackets securely.

Test Procedure
1. Verify that the tray opens freely.
2. Verify that the roller rotates so that the upper side rotates towards the drum.
Parts List
List of all the parts that will be in the FCO kit. (Under the 510F27849).

PART QTY

507E3E534 1
Attached Documentation
None
Material Disposition
None

Logistics
Approved quantities:

CSA	:	1
CSE	:	2
CSAP	:	1
CSN	:	1
CSMA	:	0
Other	:	0

PART	QTY
507E3E534	1