Product

Fuchs debris cabinet on:

• Kodak^® ThermoFlex^® Mid
  
• ThermoFlex Narrow

Background

This procedure describes how to upgrade the debris removal system by disconnecting the Fuchs debris cabinet and connecting the UDRC BP with external venting.

Requirements

Kit (part number 015-00766A)

Note: The kit is supplied with the electrical component specifications that are relevant to each customer's location. To make sure to order the correct electrical connections when ordering the kit, see Universal Debris Removal Cabinet (UDRC) Site Preparation Guide (725-00089A).
The kit is a sales item, and is not FRU.

Procedure

Disconnecting the Fuchs debris cabinet

1. Quit ThermoFlex Controller.
2. Shut down the platesetter and disconnect the main power.
3. Remove the rear trapeze from the rear of the platesetter.
4. Disconnect the Fuchs power cable from the wall socket.
5. Disconnect the Fuchs debris cabinet from the platesetter:
   • Disconnect the vacuum hose from the adaptor near the platesetter and from the Fuchs debris cabinet.
     You can discard the hose.
   • Disconnect the signal cable from the platesetter.

Connecting the UDRC

Note: The kit contains different cables for different types of power specifications. Use the cables that are appropriate for the power specifications of the country in which the platesetter is located.

1. Position the UDRC as close to the rear of the platesetter as possible.
2. Connect one end of the vacuum hose to the adaptor, and connect the other end of the vacuum hose to the hose extension on the back of the UDRC.
   
3. Connect one end of the data cable to the platesetter, and connect the other end of the data cable to the port on the back of the UDRC.
4. Connect the exhaust tube from the UDRC to the exhaust system.
5. Connect the power cable from the socket on the UDRC to the power socket on the wall.
6. Install the rear trapeze on the platesetter.

See also

• For more information on the external venting option on the UDRC BP, refer to the UDRC-BP Installation Procedure with External Venting.
• Universal Debris Removal Cabinet (UDRC) Site Preparation Guide

Document no. 709-00649A Rev A

Technical contact(s)

Content owner: Viki Arviv
See the Escalation page for escalation contacts.

Date submitted

26 Dec 2005