Trendsetter 400/800 base
MPE Controlled Release Version 2.0 (ECO CA13552, 01 Oct 2007)

NOTE:

• This CR does not apply to Trendsetters with serial number S161 and lower. Use MPE CR 1.4 instead.
• Before upgrading to this release, read the CFL upgrade information on the CFL site.
• You must have a service dongle before installing this release.
• You must install the version of Service Shell in this controlled release before downloading firmware.

Components

CR SW Kit: 20-0192C (Note: Printed copies of the Print Console Quick Start Guide are no longer distributed in the CR SW kit)
CR CD Only: CD: 651-00801A (link points to CD files on Production's master server). Order the CD from CD.Requests@Creo.com.

Trendsetter MPE Base CR2.0 Release Notes

The Readme/release notes document for Controlled Release 2.0 contains the following information:

1. Important Information
     1.1 Upgrading to CR 2.0
     1.2 Controlled Releases on Workstations
2. Controlled Release Package Information
     2.1 Component Information
     2.2 Device Qualification
     2.3 Limitations
     2.4 Dependencies
     2.5 Workflow Compatibility
3. Installation/Upgrading
     3.1 Upgradeability
     3.2 Install/Upgrade Procedure
4. New Features
     4.1 Creo Feature Licensing
     4.2 Swath Reduction for S-speed Throughput
     4.3 Test Plot
     4.4 Firmware
          4.4.1 Mainscan Shift Problem Fixed
          4.4.2 Whisker Jet Offset
          4.4.3 HDM NVS Parameters
          4.4.4 Control of Held Focus Swaths at Start and End of Plotting
          4.4.5 Narrow Mode Parameters Ignored
          4.4.6 Temperature Compensation Bug Fixed
     4.5 Print Console
          4.5.1 Support for SCSIPORT Interface
5. Minor Features and Fixes
6. Known Limitations
     6.1 Support for Power User Account
Appendix A