Trendsetter 400/800/NEWS GMCE
Controlled Release Version 2.3 (ECO CA12672, 22 Jun 2007)

NOTE:

• GMCE CR 2.3 is an update to GMCE CR 2.2. It introduces support for Flexo NX media on the base Trendsetter 400/800, and allows the use of a larger standard plate size on Trendsetter NEWS devices. The only components updated in this CR since CR 2.2 are the Trendsetter and NEWS license definition files and the TS-400-800-III_GMCE-NEWS.ini file.
• CR 2.3 is for GMCE devices with serial numbers TGxxx and NGxxx.
• GMCE CR 2.3 cannot be installed on a TMCE device.
• You must have a customer dongle, service dongle, and customer license files before installing this release or the result will be a hard-down situation.

You must install the version of Service Shell in this controlled release before downloading firmware.

Components

CR SW Kit: 634-00514A
CR CD Only: CD: 651-00656D (link points to CD files on Production's master server). Order the CD from CD.Requests@Creo.com.

Trendsetter 400/800/NEWS GMCE Controlled Release 2.3 Readme/Release Notes

The Readme/release notes document for Controlled Release 2.3 contains the following information:

1. Important Information
     1.1 Providing Feedback to Product Development
     1.2 GMCE Support
     1.3 Requirements Before Proceeding
     1.4 Upgrading to CR 2.3
     1.5 Controlled Release Installer
     1.6 Workflow Connectivity Information
          1.6.1 Print Console TIFF Downloader
          1.6.2 Brisque
          1.6.3 Prinergy
          1.6.4 Allegro Console
          1.6.5 Kodak NewsManager
2. Controlled Release Package Information
     2.1 Component Information
     2.2 Device Qualification
     2.3 Limitations
     2.4 Dependencies
     2.5 Workflow Compatibility
3. Installation/Upgrading
     3.1 Install/Upgrade Procedure
4. Features and Fixes
     4.1 Support for increased standard plate width
     4.2 Support for Trendsetter NX