Air Supply Filter/Regulator

Description |  Parts | Procedures

Description

Regulates and filters the compressed air supply

Contains filters to clean and dry the pressurized shop supply air. Filter failure can damage recorder air system and allow contaminants to enter the recorder.

TS3, TS3/8 - Located in the left side module, on the fan box rear wall. Air Filter Regulator Assembly Photo .

TS8 - Located at left side under front panel. Photo.

TSM - Located at rear of power box. Photo.

Parts

TS3, TS3/8 (55-0318)

• shutoff valve
• particulate filter (55-0324)
• coalescent filter (55-0325)
• adsorption filter (55-0326)
• pressure gauge

Replacement bowls and drain:

• Black bowl/guard, no drain 55-0693
• Black bowl/guard, manual drain 55-0694
• Black bowl/guard, Auto drain, low flow 55-0690

TS8 (55-0723)

• coarse 5 micron filter
• micro-mist 0.01 filter
• pressure gauge

Note: The air pressure gauge on Trendsetters built in Kiel have readings in BARS not PSI. Trendsetters should be set to 80 psi or 5.52 bar, and Trendsetter Autoloaders should be set to 90 psi or 6.2 bar.

Filter replacement kit—332-00003 contains:

5 micron filter
0.01 filter
O-ring, bowl and guard assembly

TSM 55-1220A

Procedures

Filters should be replaced every 3-6 months. See procedures and part numbers in Operator Guides.