Tools List

Air Supply Test Tool #92-0410A
See Procedure to test on-site air.

Universal Sensor Tester Tool #90-1112B
See Universal Sensor Tester User Guide

See Service Engineer tool kit for a list of required tools for field servicing of the Trendsetter 3244/3230 and Autoloader/Spectrum options:

Additional tools that may be required for specific procedures described in the service documentation:

• Razor blade scraper
• Flat -1/2 round file
• Tape Measure
• 6" vernier
• 12" square (for aligning the drive motor, pulley and belt)
• Pisco tube cutter
• 19 mm combo wrench (for TE shoulder bolt nut, and LE and roller cylinder rod end locknuts)
• 14 mm combo wrench (for LE and roller shoulder bolt nut, and 5/16" speed control elbows)
• 13 mm combo wrench (can be used for ½" nuts)
• 10 mm combo wrench (for adjusting the eccentric bushings on the balancing ring bearings and nut car)
• 15/16" combo wrench (for TE cylinder rod end locknuts and balance actuation cylinder mounting nut)
• 3/4" or 19 mm combo wrench (for TE cylinder rod flats)
• 5/8" or 16 mm combo wrench (for LE and roller cylinder rod flats, and drive end balance release tip flat)
• 1/2" combo wrench (for TE lock cylinder locknut)
• 7/16" combo wrench (for balance cylinder rod end locknut, ¼" speed control elbows, and TE lock cylinder rod end flat)
• 1/4" combo wrench (for TE lock cylinder rod flat, and hall sensor locknut)
• ¾" snap-on slimline wrench
• 5/8" snap-on slimline wrench
• Small rubber mallet
• GOOP adhesive (82-1011)
• 5 minute epoxy
• Cyano-acrylate adhesive (Loctite 420 or crazy glue) (for drum drive pulley key and TEC backbone assembly)
• Alvania grease
• Loctite 222 (M4 and smaller screws)
• Loctite 242 (M5 and larger screws)
• Loctite 609 (for the drum roller pins)