Product

• Platesetter 3244
• ThermoFlex
• Trendsetter 400/800
• Trendsetter Autoloader
• Trendsetter NEWS
• Trendsetter Spectrum
• Trendsetter VLF
• Trendsetter VLF Autoloader
• VLF Platesetter

Machines affected

All machines with Firmware 0 or Firmware 1.

Component

UDRC, Firmware - Air jet monitor

Error

27004/43004:  The air jet is enabled, but not turned on

Symptoms

The air jet is not on during imaging with debris removal

Cause

The air jet has been turned off in diagnostics using the ACT DBLOW OFF command, bypassing the debris task.

Solution

Synchronize the debris task by turning on the air jet using the ACT DBLOW ON command. Resubmit the job or re-issue the PLOT command.

Technical contact(s)

Tony Lamprecht

Submitted by

Ryan Hines

Date submitted

30 Sep 2003