|
|
|
|
| offset
| The swath offset or the sample offset for display.
|
|
| width
| The swath width or the sample width for display.
|
Display the plot / sample data.
|
|
| If plot data has been acquired, then the specified range of plot data is displayed in the specified format. The range of plot data is specified in swaths. If the range is not specified, then all swaths are displayed. The default format for plot data is as follows:
|
|
| <swath>:<lens position>,<focus error>,<focus sum>
|
|
| The wide format is identical but will display multiple plot data per line.
|
|
| Note that the lens position can be converted to microns by the NVS parameter foc lposcal and the focus error can be converted to microns by the NVS parameter foc errorcal.
|
|
| If sample data has been acquired, then the specified range of sample data is displayed in the specified format. The range of sample data is specified in samples. If the range is not specified, then all samples are displayed. The default format for sample data is as follows:
|
|
| <sample point>,<sample point>,etc:<sample data>,<sample data>,etc
|
|
| The first half of the line indicates the enabled sample points and includes either a "+" to signify a sample point that has been updated or a "-" to signify a sample point that has not been updated. The second half of the line displays the most recent sample data for the sample points identified by the first half of the line. If the initial value has not been determined, then the value is displayed as a "*". The wide format for sample data is as follows:
|
|
| <sample point>:<sample data> <sample point>:<sample data> etc
|
|
| The sample point indicates the sample point that has been updated and the sample data indicates the corresponding sample data.
|
|
| Whether plot data or sample data has been acquired, the default format is easier to import for analysis while the wide format minimizes the number of lines that must be transfered in a slow system.
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command log display [<offset> <width>] [wide] does not have an equivalent.
|
COMMAND: log mode (plot|sample|off)
|
|
|
COMMAND: log stop
|
|
|
ERRORCODE: [02404] The command sequence is invalid
|
|
|
PARAMETER: foc lposcal
|
|
|
PARAMETER: foc errorcal
|