Tfx Command: log sample [<point> (enable|disable)] [<divisor>]


Variables	point	Selects the sample point from 0 to 12 ( for Thermoflex ).
	point	Selects the sample point from 0 to 17 ( for Thermal 2 ).
	divisor	Selects the sample divisor from 1 to 65535.
Description	Display / configure the sample configuration. For Thermoflex, the possible sample points are as follows:
	Newline Imaging Focus Difference Focus Sum Focus Laser Current Focus Laser Calibration Lens Position Head Power Focus Temperature Focus Error Focus Actuator Current Focus Cmd Lens Position Focus control state
	For Thermal 2, the possible sample points are as follows:
	Newline Imaging Focus Difference Focus Sum Focus Laser Current Focus Laser Calibration Lens Position Write Laser Focus Temperature Beam Balance Beam Pointing #0 Beam Pointing #1 Laser Actuator Current BP Actuator Current Focus Error Focus Actuator Current Focus Cmd Lens Position Focus control state
	The monitor command log sample will display the sample configuration and the monitor command log sample <point> (enable\|disable) [<divisor>] will configure the sample point.
	Any combination of sample points may be enabled. However note that seven or more sample points will only be displayed in "wide" format. If configured, a sample divisor other than one will enable sub-sampling of the sample data.
Notes	Thermal 1.0 / 1.7x equivalents:
	The monitor command log sample [<point> (enable\|disable)] [<divisor>] does not have an equivalent.
Related Documents	COMMAND: log mode (plot\|sample\|off)
	COMMAND: log display [<offset> <width>] [wide]