Home | Contact Us | Submit Troubleshooting Info | Search | Help


    Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS

Thermal 2 Errorcode: [03543] Timeout waiting for the focus learn

Error details | Troubleshooting information

Thermal2 Errorcode: [03543] Timeout waiting for the focus learn
Thermal2 Errorcode
[03543] Timeout waiting for the focus learn

Service Information The commands implemented by the exposure head are non-blocking. As a result, the command to configure the focus control mode will only initiate the focus control mode. This error code indicates a timeout waiting for the configuration of the focus control mode.

Operator Action Call service.

Causes
  • Firmware error that will occur during firmware development and testing.

Related Documents COMMAND: sys focus state
COMMAND: sys focus (learn|adjust|on|off)

Applies to: THERMAL2
Modified: Fri Apr 20 13:24:45 2007
Updated: Thu Jul 17 02:31:36 2008
Module: SYS

Troubleshooting information

Possible cause

  

This indicates a focus learn problem.

Suggested action

  
  1. Enable verbose for focus.
  2. Disable the write laser.
  3. Run a test plot.
  4. After focus learn failure, retrieve the focus learn table using the command:
    foc get table
  5. Identify the profile of the table and correct as needed.

Related Procedure(s)

  

 

    Copyright © 2005 Creo Inc. All rights reserved. Confidential. Back to top.