Thermal 3 Errorcode: [06401] Beam-balance initialization failed


Service Information	During initialization, the beam-balance sensor subsystem attempts to read all NVS parameters and initialize the beam-balance shutter. This will initialize the entire beam-balance sensor subsystem and verify all required resources. If any error occurs, the beam-balance sensor subsystem is disabled and this error is returned for all monitor commands.
	Note that immediately after initialization, the actual error that caused the initialization failure ( as well as this error ) will be displayed on the diagnostic port.
Operator Action	Call service.
Causes	Problems with the registration of NVS parameters. This would tend to indicate a problem with the registry ( such as a corrupt registry ). Firmware error that will occur during firmware development and testing.