Thermal 3 Errorcode: [04401] Beam-pointing initialization failed


Service Information	During initialization, the beam-pointing driver attempts to read all NVS parameters and configure the beam-pointing driver. This will initialize the entire beam-pointing driver and verify all required resources. If any error occurs, the beam-pointing driver is disabled and this error is returned for all monitor commands.
	Note that immediately after initialization, the actual error that caused the initialization failure ( as well as this error ) will be displayed on the diagnostic port.
Operator Action	Call service.
Causes	Problems with the registration of NVS parameters. This would tend to indicate a problem with the registry ( such as a corrupt registry ). Firmware error that will occur during firmware development and testing.