Thermal 3 Errorcode: [05201] Laser diode initialization failed


Service Information	During initialization, the laser diode driver attempts to read all NVS parameters and configure the laser diode driver. This will initialize the entire laser diode driver and verify all required resources. If any error occurs, the laser diode driver is disabled and this error is returned for all monitor commands.
	Note that immediately after initialization, the actual error that caused the initialization failure ( as well as this error ) will be displayed on the diagnostic port.
Operator Action	Call service.
Causes	Problems with the registration of NVS parameters. This would tend to indicate a problem with the registry ( such as a corrupt registry ). Firmware error that will occur during firmware development and testing.