Thermal 3 Errorcode: [06201] Plot initialization failed


Service Information	During initialization, the plot subsystem attempts to read all NVS parameters, initialize the plot mode, configure the image timing and the image data, configure the engine synthesizer and configure the test pattern generator. If any error occurs, the plot subsystem is disabled and this error is returned for all monitor commands.
	Note that immediately after initialization, the actual error that caused the initialization failure ( as well as this error ) will be displayed on the diagnostic port.
Operator Action	Call service.
Causes	Problems with the registration of NVS parameters. This would tend to indicate a problem with the registry ( such as a corrupt registry ). Firmware error that will occur during firmware development and testing.