Home | Contact Us | Submit Troubleshooting Info | Search | Help


    Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS

Thermal 3 Errorcode: [05659] The write laser standby is not required

Error details

Thermal3 Errorcode: [05659] The write laser standby is not required
Thermal3 Errorcode
[05659] The write laser standby is not required

Service Information After the plot is complete, the host may configure the "Standby" write laser control mode to improve the lifetime of the write laser. This error code indicates that write laser standby is disabled. While the error may be normal, it should be handled internally by the firmware.

Operator Action Call service.

Causes
  • Firmware error that will occur during firmware development and testing.

Related Documents COMMAND: sys laser [on|standby|off|anneal]

Applies to: THERMAL3
Modified: Wed Jul 16 04:28:39 2008
Updated: Wed Jul 16 04:52:20 2008
Module: SYS

    Copyright © 2005 Creo Inc. All rights reserved. Confidential. Back to top.