Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Prior to loading version 8.xx S/W on the Lanplex 6000 verify that the LMM+ module is at revision 1.21 or greater (for revision 1 modules) or revision 2.12 or greater (for revision 2 modules). To verify that you have an LMM+ installed, check that the module’s ejector tab is labeled “LMM+”. To determine the revision of your LMM+, connect a terminal to the serial port of the LMM+, login as administrator, enter system, display (modules installed, slot location and revision of board will be displayed).
Software can be installed from any host that is running ftp server software (Ripro server or Macintosh with NCSA Telnet application). Software is distributed on diskettes for both UNIX and DOS platforms. Upon completion of copying software to one of these two platforms it can then be transfered to a Macintosh.
System software gets loaded into the flash memory while the system is opperating. After the flash install is completed, a quick reboot puts the newly loaded software to use.
Login: administrator <CR>
Password: <CR>
ip <CR>
interface <CR>
define <CR>
“select slot # that ftp server is connected to” <CR>
“Enter IP address (for Lanplex)” <CR>
“Enter subnet mask” <CR>
“Enter broadcast address” <CR>
“Enter cost [1]” <CR>
“Select port(s)” all <CR>
ip <CR>
ping <CR>
“enter destination ip address (ftp server)” <CR>
“IP address is alive” should be displayed
fddi <CR>
mac <CR>
location <CR>
select slot [x]: (select slot where FSM module is located
Note: slot 12 in a 12 slot chasis) <CR>
Select Fddi mac (1-2): (select FDDI DAS to utilized to bridge buses) <CR>
Select Configuration (backplane, fddiPort): backplane <CR>
Do you want to change the configuration and reboot the system (n,y): y <CR>
The switch will reboot and the disabled led will be illuminated on the selected fddi port.