Brisque

Small Dolevs 2xx/4xx with Brisque V3

Oren Keinan
13-Dec-99

After upgrading to Brisque version 3 some customers reported an over lapping of separation problem with small dolevs (200/250 400/450).

The following information will be post as a news item.

Problem Description:

When a job is sent to expose and it contains an odd number of separations, the last separation should be exposed on the part of the film that is closer to the Unload Mechanism. However that separation is exposed at the other part of the drum, (closer to the Loading Cassette), and at the end of exposure the film is advanced in the correct file size, leaving the exposed separation on the drum, and cutting only the empty half. The next exposure that will fit two separations on the drum will expose the first separation on top of the last separation of the previous job.

Problem is caused due to the fact that in version 3 the Punch is automatically activated, even if there is no punch system.

Solution:

1. If you're not using Punch System.
   Open the Expose template, change to Single mode, verify that the Punch is disactivated, change back to AutoArrange mode, and save the template.
2. If you're using a Punch System.
   Deselect the Punch in the Expose dialog.
   If Punch is necessary you need to adjust the file position according the punch offsets.