In Brisque 3.0.38, if there is no connectivity between the device and the VLSI port, error message 5152 appears


Product		Brisque 3.0.38
Platform		E30 - Victory 43P-140 - Tiger1 43P-150 - Tiger2 F50 - Wildcat (2 and 4 CPUs)
Operating system		IBM AIX 4.2.1

Error		Error message 5152.

Symptoms		After Brisque has been configured to connect to the device (via the Output Device Configuration window), if there is no connectivity between the device (Lotem and Dolev devices) and the VLSI port, the above error message appears.

Cause		Bad cable connection between SFL and VLSI.

Solution		Verify the connection between SFL and VLSI. Open the terminal and run mon4 with verify VLSI=OK then q to quit. Verify the output device is in Stand By mode. Check the board diagnostics. Shut down, then start up both the Brisque and the output device.

See also		See also Brisque to Output Device Config Troubleshooting.

Technical contact(s)		Eli Cohen
Submitted by		Eli Cohen
Date submitted		22 Nov 1999