Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
|
|
||
Product |
Prinergy 1.0 | |
Platform |
||
Operating system |
||
|
|
||
Error |
||
|
|
||
Symptoms |
For roll fed in width dimension and digital media you get full bleed, whereas for cut sheet and roll fed in long dimension you get no bleed. |
|
|
|
||
Cause |
In the Process Plan Editor, under the Layout section, at the bottom, there is an area called Marks that has Extra Sheet Margin for Marks. If this is set to zero then you won't see any bleed into the margins. If there were more than 1-up, you would see bleed into the gutters, but because this is a 1-up, there are no gutters. The "extra" margin for marks is actually also used to control the amount of bleed on margin edges. Since our default for this is 0 the default is not showing any bleed on margin edges. |
|
|
|
||
Solution |
TBD. Permanent fix: |
|
|
|
||
See also |
||
|
|
||
Keywords |
proofing |
|
|
|
||
Technical contact(s) |
Rob Prior |
|
Submitted by |
||
Date submitted |
||