Prinergy Troubleshooting - How do I turn the "composite print warning" back on in Prinergy's DCS Vector output?

How do I turn the "composite print warning" back on in Prinergy's DCS Vector output?


Product		Prinergy Connect 2.1 ; Prinergy Direct 2.1 ; Prinergy Access 2.1 ; Prinergy Powerpack 2.1 ; Prinergy Satellite
Platform
Operating system

Error

Symptoms		In Prinergy 2.2.1.0 and lower, Prinergy had a "composite print warning" which would appear when RIPping the DCS Vector in composite mode. This warning message was removed in 2.2.1.1 and higher because it interfered with some 3rd party OPI and preflight solutions. However, there might still be cases where the "composite print warning" is desired.

Cause

Solution		In the Registry, under HKLM\SOFTWARE\Creo\Araxi\Settings\Default\DCSV\JTPName\DCSCompositePrintWarning, set value to 1. Restart Vector JTPs from Prinergy Administrator. Permanent fix:

See also

Keywords		vector output

Technical contact(s)		James Bredenhof
Submitted by		James Bredenhof
Date submitted		17 Nov 2003