Error Message:

ALE: remove plate from picker (plate too large or slip sheet attached)

Applies to:

• Platesetter_3244

Service Information:

Check box loading and spec, as for operator. Check PZ brake for slipping, pz driver stalling. Check load ramp sensor, cable, (command "ramp" f/w 2.25) Check plate skew on picker at end of pick.

Operator Action:

"Clear" or "plate removed" will cause the plate to drop. Lift bridge and secure, open front door and remove plate from picker,

close machine and select "plate removed" or "clear".

Check plate size in bay that this plate was picked from.

Check that the top of the box is level with the top of the drawer.

Check that the gap between the plates and the inside top edge of the box is within 1/4".

Check that the correct box spec is loaded, (rim of box should be 1 1/2" wide).

Cause:

• At the end of the pick the plate is positioned at queue_max_z, if the upper load ramp sensor is covered at this point, then this error is reported.

See Also:

• NVS: al nlps
• NVS: alpos qmz
• Command: ramp
• Other: Troubleshooting information