Error Message:

IMAGE: Reject plate - unloading from drum

Applies to:

• Trendsetter_400/800_Auto
• Trendsetter_NEWS
• Trendsetter_VLF_Auto

Service Information:

The plate that was loaded onto the drum has been exposed ("state plate_loc d expd" set to 1) or is a reject for some reason. It is therefore being unloaded immediately. This should not happen under normal conditions.

Operator Action:

This message should only ever appear as a warning message. It means that the plate just loaded onto the drum cannot be used, so is being unloaded immediately. This should not suspend operation. If this causes trouble, contact the CreoScitex Response Centre.

Cause:

• Firmware thinks the plate on the drum was exposed.
• Firmware thinks the plate on the drum is a reject.

See Also:

• NVS: plate_loc expd
• NVS: plate_loc status
• NVS: plate_loc status2