Error Message:

HEAD: multiple edges detected - verify image position

Applies to:

• All

Service Information:

This is not an error - it is an informational message only.

While searching for the edge of the plate, the head "saw" two edges. The "media x edge" parameter was set to 2, so this condition is allowed, and the first edge is taken as the true edge.

Each time this occurs, the "state imaging double_edge_count" is incremented, and this warning message is sent to the workstation. The total count can be checked with the "list stats" command.

Operator Action:

The edge of the plate was not well defined, so the registration may be inaccurate. Check the image position on the media, and re-run the job if necessary. If this happens frequently, contact the CreoScitex Response Center.

Cause:

• Poorly cut plates
• Inconsistant emulsion
• Incorrect surface reflectivity setting

See Also:

• NVS: media edge
• NVS: imaging double
• NVS: media sr
• NVS: hdm sr
• Command: list stats