FCO #21465
Dolev 4press :
HOMC - COMP. LEVEL M
September 11, 1995

The HOMC Board is replaced with a new one to solve HOMC to PC Communication Error and to improve In Line Processor Connection.

1. Reason for Change
   Replace the HOMC board to solve problems of HOMC to PC Communication.
2. Description of Change
   Replacing the HOMC board.
3. Change Procedure
   3.1 Turn off the Imagesetter.
   3.2 Disconnect the Data cable from the HOMC board.
   3.3 Open the E-box.
   3.4 Remove the HOMC board.
   3.5 Install the supplied HOMC board (comp. level M).
   3.6 Close the E-box.
   3.8 Connect the Data cable to the HOMC board.
   3.9 Turn on the Imagesetter
4. Test Procedure
   4.1 Verify that the Imagesetter passes Startup without error messages.
   4.2 Run few exposures and make sure that the error HOMC to PC Communication Error does not appear.
5. Parts List
   503D40815 HOMC BOARD x1
6. Attached Documentation
   None
7. Material Disposition
   The old board should be sent back to STIL
8. Logistics
   Material for performing this FCO will be supplied one month after orders are placed.

Go back