FCO 21716
Dolev 4Press - Punch S-II Board

December 20, 1995

The side Punch Slave boards are replaced with new Punch S-II boards and new
flat cable to improve the system reliability.

1. Reason for Change
   The new Punch slave board must be installed with the new Punch M board
   (FCO 21563). The new board is more reliable and replaced the old board that is phased out.
2. Description of Change
   The Punch S board is replaced with Punch S-II board.
3. Change Procedure
   3.1 Power off the imagesetter.
   3.2 Remove the top cover.
   3.3 Replace all the slave boards with the supplied boards making sure
   that the board dip switches will be the same setting as the old boards.
   3.4 Connect the new flat cable from the Master II board to all the slave boards.
   The cable can be cut at the end if it is too long.
   3.5 Power on the imagesetter.
4. Test Procedure
   Check that the Punch system is working properly.
5. Parts List
   503A42095S Punch S II board x1
   504T42234 Punch F.C 20 socket x1
   203C10030 Flat cable clamp x6
6. Attached Documents
   None
7. Material Disposition
   The old boards and cables can be disposed.
8. Logistics
   Material for this FCO will be supplied two months after an order will be placed.

Subsidiary	No. of kits which may be ordered
STA	up to 24 kits
STE	up to 17 kits
STMA	up to 3 kits
STN	up to 8 kits

Go back