Dolev 800/800V/800V² - Brisque Application Issues
Film Handling Troubleshooting Hints

Accessing Stuck Media

Troubleshooting Points on the Loading System

Check the Entrance to the Output Cassette
Check the Loading Assembly Area
Check Inside the Drum Cavity

Check the Entrance to the Output Cassette

Open the unloading door and remove the output cassette. Check the area where the top of the output cassette comes in contact with the unloading chute (#8).

Check the Loading Assembly Area

1. Power off the Imagesetter using the control panel On/Off switch.
2. Open the left and right service doors (#3).
3. Open the large cassette compartment door.
4. Open the upper cassettes compartment door.
5. Open the two track locks (#5) on each side of the system.
6. Grasp the center of the locking bar and pull the system forward 10 cm.
7. Remove any media stuck inside the exposed cavity.
8. Slide the loading system back into place. Make sure the unit is locked in place.
9. Secure the two track locks on the side of the system.

Check Inside the Drum Cavity

It is possible for exposure media to jam within the drum cavity (#2). We advise that only an experienced imagesetter operator attempt to remove media from inside the machine.

1. Exercise extreme caution! Turn off the imagesetter. Open the left and right service doors. The doors are screwed shut from the inside of the main frame. To open the service doors, open the unloading door and remove the output cassette. Locate the Allen locking screw (#6), approximately 10 cm from the bottom of the main frame. Release the screw. Open each door.
2. Remove the black light-proof covers (#4) on the top left and right of each side of the machine.
3. If you find media stuck inside the drum cavity, think carefully about how to remove the media. Slowly remove any stuck media.
4. Replace the light-proof covers.
5. Close the left and right service doors.
6. Perform a media set up.