Dolev 800 Field Service Diagnostics -
Batch Tests

General
Batch Testing From Uppermost Level of the Test Tree
Batch Testing From A Lower Level of Test Tree
The Screen During Batch Testing

General

The Dolev 800 diagnostic program does not distinguish between long and short batches. Therefore either the single slash (/) or double slash (//) command can be used for batch testing. A complete diagnostic of all tests is run in less than 7 minutes.

Run the entire diagnostic program as a batch by entering a double slash, //. If any portion of the test fails, the fail message appears in the third field of the diagnostic screen.

Batch Testing From Uppermost Level of the Test Tree

The categories of the Dolev 800 test program are displayed under the heading TEST TREE. Note: The first test on the PS/2 diagnostics is the SFLM board.

The tests may be executed in a batch. A single PASS/FAIL result is displayed for the entire batch.

Example: To execute a batch consisting of all the routines in the Dolev 800 diagnostics program enter the key combination /<CR>. All of the Dolev 800 functions are tested in turn, and a PASS/FAIL result is displayed for the entire batch.

Batch Testing From A Lower Level of Test Tree

Executing a batch from a lower level of the test tree generates test results for smaller portions of the entire program.

EXAMPLE: To test the Dolev 800 and receive a PASS/FAIL result for each CRI test, use the following procedure:

Enter 5 on the keyboard to select CRI from the Diagnostics Home Screen

The Screen During Batch Testing

While batch testing is being performed, test information is displayed on the trace line. Four fields of test information are displayed on the screen: