Dolev 800 - Electronic System - Standard Controller - Power Converter and Misc. Board (503C30627)

Dolev 800 - Electronic System - Standard Controller -
Power Converter and Misc. Board (503C30627)

Description (Specifications)

LED Indicators	Four green LED indicators montior the power supply: P5V, P12V, SP12V, 18V
Temperature Hazard	A thermostat activated temperature hazard is connected to red LED and serial bus #1
Buses	Serial bus #1 is controlled by the OMC Serial bus #2 connection for revision reading
Power Supply	32 VAC from the power transformer protected by a 6.3A fuse 5VDC for digital control 12 VDC for solenoids and bi-directional DC motor 18 VDC internally generated for MOSFET switching 12 VDC bi-directional DC motor for continuous ND filter operation.
Solenoids	Four low power solenoids with power reduction: Shutter solenoid Upper door solenoid Lower door solenoid Output cassette door solenoid Two high power solenoids
Stepper Driver Supply	a VM=43 VDC (unregulated) must be supplied to the stepper driver
CRI Power Supply	a SP12 VDC (regulated) must be supplied to the stepper driver and the CRI
Operation	All of the functions and feedbacks are operated by serial bus #1 except for the shutter. The shutter is operated by the CRI.
Protection	All of the solenoids and motor drivers are overload and short circuit protected.
Diagnostics	supplied for all of the solenoids, motors, VM and SP12V
For (Dolev Option) Optical Reflective Device	switchable +5V DC f

Switch the machine OFF.
Open the right side door of the Dolev 800 & the standard controller cover.
Release the board and remove it from the crate.
Install the new board.
Close the right side door of the Dolev 800 & the standard controller cover and restore power.