Dolev 800 -Loading System Installation Procedure

Replace the loading/unloading system

The Loading & Unloading System (zoom image)

Before You Start
Tools and Accessories
Install (Replace) Loading System on Imagesetter

Before You Start

1. Two engineers are required when removing the assembly. Do not attempt to remove the system from the Imagesetter unless at least two engineers are present.
   
   
2. Much of the service requires only that the assembly be unlocked and moved forward. This level of service does not demand a second engineer.
   
   
3. Before you remove the loading and unloading system, make sure you have enough space around the machine to pull out the assembly.

Tools and Accessories

Flat screwdriver
Phillips screwdriver

Install (Replace) Loading System on Imagesetter

1. With an engineer on each side of the assembly, lift the replacement assembly into place. Set the wheels of the new unit on the tracks.
   
   
2. Connect the electrical harness.
   
   
3. Push the assembly as far as it goes in a steady motion.
   
   
4. Close the track locks and again push the unit gently until you hear the assembly click into place.
   
   
5. Fasten the light-proof covers. Re-assemble the E-ring (#84) that secures the top of the left lift-o-mat piston.
   
   
6. Close the side service doors.