Dolev 800 Field Service Diagnostics -
Running Diagnostics From A Laptop Computer

Getting Started
Working From the Diagnostics Home Screen

Getting Started

To operate the Dolev 800 Diagnostics from a laptop computer, perform the
following steps:

1. Connect the laptop RS232 cable (Cat. No. 504G34023A) between the laptop and the Standard Controller COM1 port.
   
   
2. Insert the Diagnostics diskette into the 3.5 inch floppy drive on the front right side of the imagesetter.
   
   
3. Power off the imagesetter. Wait ten seconds and power on the imagesetter.
   
   
4. Power on the laptop.
   
   
5. On the laptop, open the Windows TM application. Select the Dolev Diagnostics icon. If there is no Windows TM Dolev Diagnostics icon, you need to create one. (See Creating a Windows Dolev Diagnostic Icon)

Working From the Diagnostics Home Screen

The top level of the Dolev 800 diagnostic tests is displayed under the heading TEST TREE. The first four tests are board tests of the standard controller electronics.

Select the number of the appropriate test category from the TEST TREE menu by entering the number beside Operation>. Example: to choose CRI:
Operation>3

Note:

Tests in capital letters indicate the presence of additional sub-tests.

Press <esc>, to stop diagnostics during EXECUTE. The diagnostic routine will not continue on to the next test.

If you want to select which of the tests to run in the diagnostics, go to the command line, operation >, and enter SSS.

 

Example, operation > SSS

All of the TEST TREE options appear with the question [Y/n]. You use the cursor to move down the list, and the <CR> to confirm a choice.