Home | Contact Us | Submit Troubleshooting Info | Search | Help


    Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS

Replacing an axle holder assembly

Product

   Dolev 800 V3/4

Background

  

This procedure describes how to replace an axle holder assembly (axle holder assy, P/N 290A6B745).

Procedure

  
  1. Turn off the machine and disconnect the main power cable.
  2. Slide out the loading system.
  3. Remove the close cable chain by loosening the two chain tension screws on the axle holder assy.
  4. Remove the two Allen screws from the axle holder assy.
  5. Insert the new axle holder assy, and secure it by inserting and tightening the two Allen screws.
  6. Insert the close cable chain.
  7. Reinsert the loading system.
  8. Connect the main power cable and turn on the machine.

Images

  

Test

  

Load film and verify smooth operation.

See also

  

Dolev 800 V3/V4 Error Messages
Technical contact(s)
  

Content owner: Oded Zaccai
See the Escalation page for escalation contacts.
Date submitted
  

17 Jun 2002

Popups / Tool Tips for this Page

Close this popup...

  1. Open the front, side, and top doors.
  2. Remove the right and left side covers.
  3. Pull out the right and left loading system locks.

Popups / Tool Tips for this Page

Close this popup...

  1. Slide the loading system into the machine.
  2. Release the right and left loading system locks.
  3. Verify that the loading system is locked in place by shaking it gently.
  4. Install the right and left side covers.
  5. Close the top, side, and front doors.

    Copyright © 2005 Creo Inc. All rights reserved. Confidential. Back to top.

Popups / Tool Tips for this Page

Close this popup...

  1. Loop the close cable chain around the gear wheels.
  2. Push the axle holder assy downwards to stretch the chain.
  3. Tighten the two Allen screws on the axle holder assy.