Product

Background

This procedure describes how to replace a pin assembly (pin assy, P/N 290A6B527).

Procedure

1. Turn off the machine and disconnect the main power cable.
2. Slide out the loading system.
3. Remove the close cable chain by loosening the two chain tension screws on the axle holder assy.
4. Remove the three Allen screws on the pin assy and remove the pin assy together with its base plate.

Note: When you remove the three Allen screws, the chain on the inner side of the pin assy is also released.

5. Insert the new pin assy, then insert and slightly tighten the three Allen screws.
6. Assemble the inner chain.
7. Assemble the close cable chain.
8. Reinsert the loading system.
9. Connect the main power cable and turn on the machine.

Images

Test

Load film and verify smooth operation.

See also

Dolev 800 V3/V4 Error Messages

Technical contact(s)

Content owner: Oded Zaccai
See the Escalation page for escalation contacts.

Date submitted

04 Jun 2002