Lotem 400 Family - Software version CD 1.50.08 Patch Information

Lotem 400 Family - Software Version CD 1.50.08 Patch Information

Product: Lotem^® 400 Family with software version 1.50.08

The purpose of this document is to clarify which patches are required for CD version 1.50.08.

Patch 1 = Omron interlocks (relevant only if machine has Omron interlocks)
Patch 2 = Edge detection improvement
Patch 3 = Throughput improvement for Quantum (not mandatory)
Patch 4 = New head grippers to correct registration problem (relevant only if machine has new head grippers)
Lotem Expose patch = for Lotem Expose application

Note: All patches and files can be downloaded from TechPlanet. See the downloads page for the relevant product.

	Patches required	Files required	Notes
Lotem 400 small, standard	1 2 4	-	-
Lotem 400 PS/M	1 2 4 Lotem Expose Script Change: configloadingsyst	msvcrtd.dll mfc42d.dll (to install application)	This Lotem open configuration does not support com2 object See Notes, below
Lotem 400 Quantum	3 4	Quantum firmware 1.20.05 Xilinx 1.37	These files enable exposing small plates.

Notes for PS/M:

The .dll files are located on the 1.50.08 CD. Before software installation, insert the 1.50.08 CD and copy the .dll files to the C: WIN NT/ SYSTEM folder, and then install the application.
To expose, set the registry key to 0, as follows: HKEY_LOCAL_MACHINE\SOFTWARE\Scitex\Projects\LOTEM400V\MACHINE\Lotem Open Configuration (yes=1, No=0)
This causes the Lotem application to behave like an MCU and not a PS/M.
The Lotem GUI looks smaller, and is different than the PS/M configuration GUI.
User must activate the Lotem application, and then activate the Lotem expose manually.

See also: Lotem 400 Latest Machines Released (pdf table)