Installation Item

Complete

1. Site preparation

¨

2. Hardware installation

¨

3. Check for damage

¨

4. Unpack and position the platesetter

¨

5. Voltage setting

 ¨

6. Unpack & assemble cassette loading trolley

¨

7. Remove shipping guards

¨

8. Height adjustment of platesetter

¨

9. Plate conveyor assembly and connection

¨

10. Processor positioning

¨

11. Power and air compressor connection

¨

12. Operation monitor connection and cable setup

¨

13. power up

¨

14. Network setup/time setting

¨

15. Software check and start up

¨

16. Brisque unpacking & setup

¨

17. Brisque connection (TCP/IP address, fibers)

¨

18. Brisque configuration

¨

19. Punch installation

¨

20. Install and adjust the punches to the customer’s press

¨

21. customer configuration setting

¨

22. Set press formats

¨

23. Set plate size

¨

26. Lotem check

¨

27. Load/unload system

¨

28. Drum motion

¨

29. Interlocks system

¨

30. Laser status

¨

31. Observe smooth plate movement at punch entry

¨

32. Good reach at short pins

¨

33.Check plate on drum  and   make sure the plate is touching the pins on drum

¨

34. Check tail gripper on plate

¨

35. Check paper disposal stage and adjust if needed

¨

36. Exposure Test

¨

37.Check and adjust focus. If you change the focus value, make sure to change plate constant conversion thickness in registry (the value should be 300+ focus value for 0.3 mm plate).

¨

38. Calibrate and set Intensity table for res. 60, 80, 100, 120, 140. Save the table on Lotem (don’t use the save option from Brisque).

¨

39. Check and adjust if needed Res. Motor table for res. 60, 80, 100, 120, and 140.

¨

40.Check and Adj. Delay

¨

41. If installing a Lotem 800² , check  uniformity calibration and make adjustments if necessary

¨

42. Expose a 4-plate job and check the results for quality, centering and registration

¨

43. Save the Registry and DataBase on a new floppy.
Save the files on your laptop.

¨

44. Processor check 
If you work with Kodak, save and write down the heavy fog temperature and the fog temperature. all the other plate, write down the processor speed and temperature.

¨

45. Excurve calibration

¨

46. ATP of customer formats

¨

47. Perform a customer job

¨

48. calibration

¨

49. Parallelism check of image to press punches

¨

50. Press runs

¨

51. Tone reproduction buildup

¨

52. training

¨

53. Hardware training

¨

54. Brisque functionality training

¨

55. Workflow setup

¨

56. Show the coustomer how to handle plates: plate loading in cassette, plate definition for new plate, change cassette

¨

57. Show the customer how to open and close doors, how to use the cheaters, explain the importance of laser interlocks

¨

58. Show the customer how to move tail grippers to preload position and how to perform Init XY, Init Drum, Preload and New Plate.

¨

59. Show the customer how to move the head to the end position and how to clean the lens cover.

¨

60. Show the proper shut down and start up of Lotem application

¨