Lotem 800V - Troubleshooting

Home | Contact Us | Submit Troubleshooting Info | Search | Help

Load/Unload Problems

Boards :

Problem	Solution
DDB card failure - The DDB doesn’t respond	Re Load the DDB altera use send all button (Add pic of DDB board as link). Check if the GUI in the machine is defined correctly to Tsp./ Vlsi. (Add pic of screen processor type as link). You need to make sure that it defines correctly. Check all the wiring from the DDB to the boards in the L-Box. (Add pic of tsp1, 2 as link). Run Diagnostic to the Board. Reload the version. Check the NUC comp level it should be N. Replace the DDB board.
MCF board folder is empty.	Reload the software Reload the registry Reload the database.
MCF card start up error.	Restart the machine. Check if the error occurs again. If it does, replace the board.
Communication problems Between the Machine to the Brisque.	Check the network cable and the wiring of the Tsp. / Vlsi to the machine. Check the TCP-IP definition at the PC. (Link to file Tcp ip connectivity) Perform configuration. If it’s Vlsi do ‘Mon4’. If it’s Tsp. do ‘MonNsp’. Do Ping to the machine.
Local board gives error “put and get..”	See Tip No 6.
CPU bios is corrupt.	Configure the CPU bios after replacing the board.
DDB returns illegal buffer error message.	See Tip No 41.
Brisque gives communication error messages	TSP / Vlsi Error message that may appear 5151, 5152, 5153, 5154, 5155 See the following instructions
Start up problems with the Lotem application.	Replace the NUC board. Try to re plug the boards and wiring .It might be a communication problem between the boards.
Expose parameters are not valid	Check that the parameter "IO OBJECTS\ DDB CARDS\ DDB Card\ Minimum DDB Divider" should be always 1.