Product

Platform

PC

Operating system

Windows

Background

Lotem Controller software works hand-in-hand with several firmware applications. This document provides instructions for installation of the pattern data firmware application that is compatible with Lotem Controller 3.50.07.

Requirements

Lotem Controller software version 3.50.07

Procedure

1. Verify that Lotem Controller software version 3.50.07 is installed.
2. Save the following file to to a floppy or other disk:
   • Pattern Data: 1.01 (mcedata.bin)
3. Shut down the Lotem application, as required.
4. Close the Splot program, as required. This frees the serial port.
5. Access the DOS prompt.
6. At the DOS prompt, type C:\th2\tools\bload f=mcedata.bin i=data p=8. The pattern data firmware begins to load.
   Note: When the pattern data firmware has loaded successfully, the DOS prompt appears.

Test

After all firmware applications have been installed, you can verify successful installation by typing QUANTUM>>sw dir. A list of installed firmware applications will appear.

See also

Lotem Controller software version 3.50.07 compatible firmware

Technical contact(s)

Meir Dana
See the Escalation page for escalation contacts.

Date submitted

18 Jul 2002