Product

Lotem™ Quantum Spectrum

Platform

PC

Operating system

Windows

Background

PC controller software works hand-in-hand with several firmware applications. This document provides instructions for installation of the TMCE main firmware application that is compatible with PC controller 3.70.02.

Requirements

PC controller software version 3.70.02

Procedure

1. Verify that PC controller software version 3.70.02 is installed.
2. Shut down the Lotem application, as required.
3. In the PC controller, start the Splot program.
4. In the Splot monitor, type QUANTUM>> reset boot. The A Boot>> prompt appears.
5. Close the Splot program. This frees the serial port.
6. Access the DOS prompt.
7. At the DOS prompt, type one of the following:
   Note: Either one may be typed. Do not type both.
   • C:\th2\tools\bload f=QuantumFmw120-03.bin p=8 i=main.
   • C:\th2\tools\bload f=mcefirmware.bin p=8 i=ica
   The TMCE main firmware starts to load.
8. When the TMCE main firmware has loaded successfully (the DOS prompt appears), open the Splot program.
9. In the Splot monitor, type BOOT>> reset.
10. In the Splot monitor, type QUANTUM>> scan eh_&Logicpower bon.
11. In the Splot monitor, type QUANTUM>> reset. The TMCE main firmware is installed.

Test

After all firmware applications have been installed, you can verify successful installation by typing QUANTUM>>sw dir. A list of installed firmware applications appears.

See also

PC controller software version 3.70.02 compatible firmware

Technical contact(s)

Nir Peleg
See the Escalation page for escalation contacts.

Date submitted

28 Aug 2002