Product

Magnus 800 platesetter

Background

The fine detector assembly ensures that the fixed registration pin reaches the defined home position.

This procedure describes how to remove and replace the fine detector assembly, including the slotted detector.

Procedure

Removing the fine detector assembly

1. Obtain a punched plate from the customer. This plate will be used as a reference plate for testing the procedure.
2. Remove the alignment system from the platesetter and place it on a work table.
3. The fine detector assembly is located on the right side of the alignment system. Disconnect the detector connector from the slotted detector (part number 503-00187A):
   
   
   
   
4. Use a 3-mm hex key to remove the two screws securing the fine detector assembly bracket to the alignment system:
   
   
   
   
5. Extract the bracket and the slotted detector:
   
   
   
   
6. Use a 3-mm hex key to remove the two screws securing the bracket to the slotted detector.

Replacing the fine detector assembly

Important: Unless otherwise stated, coat all screws in Loctite^® 242.

1. Use a 3-mm hex key to insert and tighten the two screws securing the bracket to the slotted detector. (View image)
2. Install the bracket (and slotted detector) onto the alignment system:
   
   
   
   
3. Use a 3-mm hex key to insert and tighten the two screws securing the fine detector assembly bracket to the alignment system. (View image)
4. Connect the detector connector to the slotted detector. (View image)
5. Reinstall the alignment system into the platesetter.

Test

See the Test procedure for replacing the alignment system.

Technical contact(s)

Content owner: Itai Peperovich
See the Escalation page for escalation contacts.

Date submitted

22 Feb 2005